Samsung Galaxy A25 5G A256E ISP PinOUT

In this guide, we will provide the actual image of the UFS ISP pinout and test point for the Samsung Galaxy A25 5G A256E. With the ISP Pinout, you can easily restore the stock ROM, bypass FRP lock, or reset user data using the Z3X EasyJTag Box Tool or UFI toolbox.

You can use this pinout to reset the user lock FRP, write a UFS dump, and erase the MDM lock on the Samsung Galaxy A25. The Samsung Galaxy A25 5G A256E UFS ISP Pinout and instructions on how to use it can be found here.

By following the detailed tutorial and pictures below, you can easily find the UFS ISP Pinout connection for the Samsung A25 A256E. This will allow you to bypass the FRP lock or reset user data on your device using the ISP Pinout with EasyJTAG Plus Box or any other compatible tool. Be sure to check out the guide below for step-by-step instructions.

What is Samsung Galaxy A25 5G A256E UFS ISP Pinout?

UFS ISP PinOUT refers to the Universal Flash Storage In-System Programming PinOUT. It is a set of pins on the device’s circuit board that allows direct access to the flash memory. Advanced users and technicians can bypass the typical software interfaces and directly interact with the device’s storage system by connecting to these pins.

Samsung Galaxy A25 5G A256E Repair Dead boot, Flashing, remove FRP lock and any brand phone.EasyJTAG Plus is the only box that supports UFS. Some phones need those boxes after flashing the wrong firmware and not booting. If you had those boxes for boot repair, it would be great. Removing a pin, pattern, password, FRP, or MDM lock on some brands is impossible. You can remove locks with this.

Samsung Galaxy A25 5G A256E UFS ISP Pinout Image

First, take your phone’s back cover off. Then, remove the battery, fingerprint reader, and camera from the motherboard.
Unscrew the screws that hold the motherboard in place, carefully remove it, and put it in a safe place.
Find the TxOp, TxOn, RxOp, and RxOn pins for the eMMC on the device. You might have to cut through the steel cover to get to them.
Get the UFI box, then take the adapter out of it. The pins on the adapter should be the same as the ones listed in the last step.
Between the base and the adapter, use jumpers to connect the four pins (TxOp, TxOn, RxOp, and RxOn). Leave the USB to power the VCC and VCCQ.
Put the connector into the UFI box and connect the box to your computer.
Connect the battery to the computer again. Then, connect the phone to your computer using the USB connection.