Here is the tested and working solution of the Xiaomi Poco X3 Not Charging Problem, Charging ways, and USB jumper, This mobile charging problem does not easily make a bad part, and though it is worse, the charging connector. So this mobile charging problem arises Then first switch the charging connector. And if the problem is not resolved even after the charging connector is changed. If you see the picture that I gave the picture, your jumper. Below I’ll tell you to step by step, how do you solve this problem.
Xiaomi Poco X3 Charging Ways Solution
In the below image we draw the Xiaomi Poco X3 charging ways and its jumper check continuity using a multimeter if any track damage makes a jumper on the Xiaomi Poco X3 motherboard.
- First, open the mobile
- Then clean the section of the charging connector of the mobile motherboard
- Then remove the old charging connector and add a new connector
Hardware Reasons for Xiaomi Poco X3 Charging Problem
There are four basic hardware-related reasons that your Xiaomi Poco X3 could be charging slowly, and I will explain each of them in turn and in order of increasing probability. The issue could be:
- There is dirt, dust, or debris lodged in the charging port.
- The power adapter is damaged or faulty.
- The USB cable is no longer working properly.
- You are using the wrong power adapter for your phone, or a weak USB port.
How To Repair Xiaomi Poco X3 Not Charging Problem:
Xiaomi Poco X3 Charging Ways Charging Jumper Solution Slow Or Fake Charging Solution
After the mobile phone disassembles, you will need to take some steps shown in the diagram above.
Check the Charging jack and its points do they have good value if yes, then change the changer and check it and if the motherboard does not see the accurate value with the charging points, then after the dissatisfaction of the mobile phone you get something shown in the above diagram You have to take steps.
Check the Charging jack and its points are good values if yes, then change the changer and check it and if the motherboard does not see the accurate value with charging points, then you will see all the parts and tracks given in the diagram of Xiaomi Redmi 10X Are to investigate.
If any corrosion or carbon and water damage or any component are damaged, then the motherboard should be replaced carefully. If a track is lost then the jumper is applied and if any part is damaged or broken, replace it with the new one.
More information about this problem and solutions for new tips and tricks are going to this page, if there are new updates, there will be updates. Below are some related posts, you can read more about mobile phones.
