Redmi 6 Pro ISP Pinout or EMMC Ways for ufi box easy jtag is now available for download, by using this pinout you can remove Xiaomi Redmi 6 Pro user lock FRP reset. You can easily get the ISP Pinout EMMC connection of the Redmi 6 Pro by following the full guide below along with images. By using the ISP Pinout, you can easily bypass FRP lock or reset user data on your device via UFi Box, AE-tool, or any other tool. Check out the below guide.
Remove Pattern Lock, Screen Lock, Finger Lock in Redmi 6 Pro with UFI Box you can easily solve with this method if you are fresher technician or experienced technician in android software related if the error occurs of USB not recognized then your USB is not working. if a battery is not charged, your USB socket will not properly work and you will fail in this method. if any issues please write your questions in the comment box I will try my best to help you.
Redmi 6 Pro MI Account remove repair dead boot or any brand phone you need two dongles best in the market one is easy jtag plus and another is ufi box both are best in the market. those boxes help some phone after flashing wrong firmware not show booting on-screen.this you need those boxes for boot repair. some brands, not possible lock remove like a pin, pattern, password, FRP, and MDM lock this really supports for remove locks.
What is ISP Or eMMC Pinout?
ISP or In-system programming also known as in-circuit serial programming for hardware that has a cross-reference of pins or contacts. By shorting the pins together, you can power or signal the logic board (motherboard) of an electronic device such as a mobile.
The eMMC solution consists of at least three components – the MMC (multimedia card) interface, the flash memory, and the flash memory controller – and is offered in an industry-standard BGA package.
Redmi 6 Pro ISP Pinout Image
So that later when you want to direct again you are not confused looking for the Direct Pin, please boss just save it on HDD boss so that at any time there are cases that can be used again, congratulations, try the boss. one, please jumper for VCC VCCQ CLK CMD D0 GND for GND or ground don’t forget the jumpers are also bosses, otherwise, the jumpers don’t connect later.
How To Remove Redmi 6 Pro User Lock FRP Using UFI Dongle:
- Remove the back panel of the device and connect the wire to the ISP Pinout.
- Next, connect the correct ISP Pinout to the UFi Box
- Check “Direct eMMC (ISP)”
- Then Click on “Identify eMMc.
- Connect your Redmi 6 Pro to the PC via a USB cable.
- Head over to the PC and open Device Manager.
- If your device is located there, run the UFi Box.
- Go to USERAREAPART
- Now Click on Special Task ► [Oppo] MasterClear ► Wipe Data Only
- Now Click on Special Task ► Clear FRP Lock
- Done.
