looking for Xiaomi Redmi 4X charging problem solution USB charging ways how to repair Redmi 4X charging problem then you landed at the right place here you fill find full detail diagram of Redmi 4X charging ways, battery connector jumper and charging solution.
For example, you will be unable to charge your phones using the phone’s direct USB chargers, the universal charger usage becomes impossible when you use a phone powered by an inbuilt battery.
This mobile charging problem does not easily make a bad part, and though it is worse, the charging connector. So this mobile charging problem arises Then first switch the charging connector. And if the problem is not resolved even after the charging connector is changed. If you see the picture that I gave the picture, your jumper. Below I’ll tell you to step by step, how do you solve this problem.
Redmi 4X Charging Problem Solution
In the below image we draw the Redmi 4X charging problem ways and its jumper check continuity using a multimeter if any track damage makes a jumper on Redmi 4X motherboard.
- First, open the mobile
- Then clean the section of the charging connector of the mobile motherboard
- Then remove the old charging connector and add a new connector
How To Repair Redmi 4X Not Charging Problem:
Redmi 4X Problem Charging Ways Charging Jumper Solution Slow Or Fake Charging Solution
After the mobile phone disassembles, you will need to take some steps shown in the diagram above. Check Charging connector and its points do they have good value if yes, then change the changer and check it and if the motherboard does not see the accurate value with the charging points, then after the dissatisfaction of the mobile phone you get something shown in the above diagram You have to take steps. then you will see all the parts and tracks given in the diagram of Redmi 4x Are to investigate.
Below are the most common causes of why you Redmi 4X have trouble charging, and other problems concerning the battery like the grey battery issue:
- Shorted/faulty diode
- Shorted/faulty capacitors
- faulty resistors
- Bad/damaged charging coil
- Shorted/faulty IC
- Bad USB Port
- Partial contact
If any corrosion or carbon and water damage or any component are damaged, then the motherboard should be replaced carefully. If a track is lost then the jumper is applied and if any part is damaged or broken, replace it with the new one.
More information about this problem and solutions for new tips and tricks are going to this page, if there are new updates, there will be updates. Below are some related posts, you can read more about mobile phones.