Samsung Galaxy J2 Pro J250F Battery Connector Ways Battery Jumper
This article is about repairing solution for Samsung Galaxy J2 Pro J250F battery connector. If your phone’s battery connector is damaged somehow you can always replace it with a new one, but if the battery connector’s prints are damaged then the diagram in this article can be helpful to you.
Damage to the battery Samsung Galaxy J2 Pro J250F could be of the causes for the phone does get wet, padded seat battery connector corroded and rusted breaking lines.
Samsung Galaxy J2 (2018) specifications
Samsung Galaxy J2 Pro (2018) smartphone was launched in January 2018. The phone comes with a 5.00-inch touchscreen display with a resolution of 540×960 pixels at a pixel density of 220 pixels per inch (ppi) and an aspect ratio of 16:9.
Samsung Galaxy J2 Pro (2018) is powered by a 1.4GHz quad-core processor. It comes with 1.5GB of RAM.
The Samsung Galaxy J2 Pro (2018) runs Android 7.0 and is powered by a 2,600mAh non-removable battery.
Please Note that we will edit these solutions or add new ones if found on this page at any time in the future. So feel free to come back any time on this page to stay up to date.
Here are Samsung A810F Battery Connector Ways Problem Solutions. Please study these diagrams very carefully before you start repairing.
Samsung Galaxy J2 Pro J250F Battery Connector Ways:
“any damage resulting from the tips is not our responsibility”
Diagnostics:
If Samsung A810F is not getting power ON, Replace the battery and try to power it ON. Plug in charging pin into the jack and try to make it charge. Check battery terminal’s +v and -V points with electronics meter.
Solution:
Disassemble the phone Samsung Galaxy J2 Pro J250F and check battery connectors if these are loose or not fix. Then check the whole motherboard for water and rust damages, Carbon or broken parts.
If find some rust or carbon make it clean with electronics cleaner and apply hot air with a heat gun to make it dry.
Find out these parts that are identified in the above diagram and make a check for volts. I find some broken parts or tracks are missing then apply jumpers as given in the above diagrams.
If you have further questions please don’t hesitate to leave a comment.
Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.
