Samsung Galaxy S7 G930F Battery Connector Ways Solution
Samsung SM-G930F Battery Connecter Jumper Battery Point Ways Solution BSI Line Was Power Problem SOlution Set Dead.
Samsung Galaxy Note 3 N900 battery Low then Shutdown or restart set dead fault caused by either a faulty resistor and capacitor. Here we want to share the experience how to repair this kind of damage.
Damage to the battery Samsung Galaxy S7 G930F could be of the causes for the phone does get wet, padded seat battery connector corroded and rusted breaking lines.
Here are tips on battery connector lines, check the track as in the picture below, if there is a path-breaking or not, if there is a path-breaking try doing jumpers carefully to avoid short-circuit condition of the phone.
Hardware Solution:
“any damage resulting from the tips is not our responsibility”
First you need to know what is mean bsi ? The BSI pin is used for battery status indicator. 5.6 kΩ to 10 kΩ resistor value will can be used on normal mobile battery cells From ground ! To make for bsi point.
When BSI not connected with to the mobile phone ! The mobile phone will not can perform as normal.
- Sometimes dust can also resist bsi point. Then Some mobile Phone will not be power on. And mobile phone will also can perform restarting several times during on power on.
- So, if you have also query about Samsung Galaxy S7 G930F restarting problem ! First you need to clean your Samsung SM-G930F battery connector bsi point.
- In some of the different mobile like, Nokia or also with some old model of Samsung mobiles ! Mobile cells will can perform Insert Sim Card problem if battery bsi point was not connected.
- So, You need keep this on your mind Samsung Galaxy S7 G930F battery connector bsi point is the very important and it need to be neat and clean.
Diagnostics:
If Samsung Galaxy S7 G930F is not getting power ON, Replace the battery and try to power it ON. Plug in charging pin into the jack and try to make it charge. Check battery terminal’s +v and -V points with electronics meter.
Solution:
Disassemble the phone Samsung SM-G930F and check battery connectors if these are loose or not fix. Then check the whole mother board for water and rust damages, Carbon or broken parts.
If find some rust or carbon make it clean with electronics cleaner and apply hot air with a heat gun to make it dry.
Find out these parts that are identified in above diagram and make a check for volts. If find some broken parts or tracks are missing then apply jumpers as given in above diagrams.
Samsung Galaxy S7 G930F, Battery Terminal, Battery Points, Battery Jack Problem, Battery Terminal Solution, Battery Terminal Jumpers, Battery Power Ways
