Lenovo A6000 Power Button Ways On-Off Key Jumper
Lenovo A6000 Power Key Jumper On Off Button Ways Set Is Dead Power Problem Repair Solution
Here’s the solution to repair Nokia 3310 power ON/OFF switch problem.
This problem may cause the device unable to power up when hitting the power key. The problem may easily configured if the power ON and OFF switch key has no response, but the device is not totally dead for it shows a charging indication when you charge it up. Now, this solution simply shows the line paths (ON OFF ways)of the power key.
If you are facing an power problem in Lenovo A6000 diagrams in this article can help. Continue with the following troubleshooting solutions and establish bridges necessary for the points that have been damaged.
Hardware Solution:
Lenovo A6000 Power On Off Key Jumper, Track, Ways
The very first thing that you need to do is to check battery voltage at its terminals in order to verify whether the problem is with the battery or with anything else. (Battery voltage should be at least 3.8V).
If the battery voltage is lower than 3.8V or is not showing charge then it means you need to change your battery in first place and check.
The very first thing that you need to do is to check battery voltage at its terminals in order to verify whether the problem is with the battery or with anything else. (Battery voltage should be at least 3.8V).
If the battery voltage is lower than 3.8V or is not showing charge then it means you need to change your battery in first place and check.
Now check battery connectors physically for any physical or water damage. In case it is water damage than clean the battery contacts. Besides that, also re-solder these battery contacts and make jumpers.
In case all of the above method doesn’t resolve your problem then check the entire board for any traces of water damage gently heat or re-solder if needed.
Lenovo A6000 Power Button, Power Key, Power Switch, On Off Button, On Off Switch, Power Problem
