iPad Air Charging Problem Jumper Ways Solution

iPad Air Charging Problem Jumper Ways Solution
iPad Air Charging Jumper, Charging Solution, Not Charging Problem,  Charging Ways Fake Charging Solution

Here is the solution for Apple iPad Air Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by a faulty charger or faulty components on iPad Air PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist.

Before proceeding, ensure that the battery and the battery charger are in good working condition.
– Check all the components shown in the image below, you may start by checking the USB pin connector.
– Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
– Trace each of the connection line paths from USB pins down to the components where it is directly connected.

Hardware Solution:

Now re-solder charging connector pins and check.
Check charging voltage with the help of a multimeter. Place Negative terminal of the multimeter on ground and Positive on a charging pin (1st pin from your left-hand side).
Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector.

All of the above steps will surely help you to resolve your iPad Air charging problems in the best possible manner. If you are lucky enough then simple workaround method will get the job done for you.

If you have further Questions please leave a comment.
Note: Please note that even though every solution posted on our website is tested by one or more members of our team before posting, but still we do not take any responsibility for any damage it may cause to your cell phones. Use these repairing solutions at your own risk. Thank You.