Samsung Galaxy Note 5 N920C Power Button Ways On-Off Key Jumper Solution
Samsung Galaxy Note 5 N920C Power Button Ways Power ON-OFF Key Track, Jumper Ways Solution This solution provides the connection line paths of the Samsung SM-N920C Power ON-OFF/END switch button key. This may help fix if the phone doesn’t tuns ON but it shows charging indication when the battery charger is plug-in.
So if your Samsung Galaxy Note 5 N920C power button is not working to repair it you just need to replace it with a new one. If the prints of the button are damaged then you are going to have to make the jumpers as shown in the diagram.
To fix this problem, you may need to clean first the power key’s contact pads for possible oxidation build up. If it seems cleaned but however still doesn’t respond, refer to this solution below for it shows the connection line paths of the power key, then do some test and tracing procedures.
Just refer to the solution below and locate the highlighted components where the said power on off key is being connected.
Samsung Galaxy Note 5 N920C Power Button Ways Hardware Solution:
The highlighted components above is where the power switch is being connected, if these components were damaged it will result to power switch failure. You may need to check and then replace these components as well.
There is a risk that the power switch on Samsung SM-N920C may sometimes damaged and the switch terminal solder pads will be lifted and found hard enough to install it back. If these happens you may need to strongly bond the power switch to its original position and do a apply a jumper wire on it is one of the option.
You can use the solution above to determine which particular components you can put and solder a jumper wire when needed.
Repair hints for Power Switch problem on Samsung Galaxy Note 5 N920C:
1. Check the power switch assembly, if the assembly is damaged replace the switch.
Sometimes even if the powerswitch is not not visually damaged, see to it that it still working by using a
multimeter
2. For lifted button switch solder terminal pads on the PCB board, manage to re-establish the switch to its original position and bond it perfectly so that it won’t easily break. Then manage to reconnect the power switch line paths and the ground connection. If you can see an empty components solder pads just below of it, you can connect it to that spot. that is also connected to the power switch.
Samsung Galaxy Note 5 N920C Power Button Ways, On Off Key Jumper Solution, Set Is Dead Problem
Samsung SM- N920C,Power Button,Power Key,Power Switch,On Off Button, On-Off Switch, Power Problem
