Samsung SM-G130E Charging Jumper Solution Usb Ways
Huawei P6-U06 Charging Ways Usb Jumper Solution
In Huawei Ascend P6 U06 USB cable connector is also used for charging the phone. Because of excessive use or any other reason USB connector can be damaged.
So if you are experiencing any charging problem or problem connecting your Huawei Ascend P6 U06 Charging Ways Solution Usb Jumper to your computer via USB cable then it is possible that your Huawei P6 charging connector is faulty. Replacing it with a new one is the only solution here. But if by any chance the USB connector prints are broken then you have to make the jumpers as shown in the diagram below.
First check the fuse if open or damaged, second check the diode if shorted. Check the resistor near the power IC. Re-solder or replace if damaged. Trace the VCHARGE (charging voltage) line paths and the ground of the charging pads.
Resolving Huawei Ascend P6 U06 charging problem:
Normally Huawei Ascend P6 charging problem is due to faulty charging connector, and in order to overcome that, all you have to do is to:
Remove Battery cover, Battery and C cover, then check charging connector’s pins
First Clean and remount all the pins of charging connector.
Put Battery in again and connect charger.
Then check the fuse and the and the diode, replace if found damaged.
If you have further questions please don’t hesitate to leave a comment.
Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.
Huawei Ascend P6 U06 Charging Solution Jumper Problem Ways No Charging Not Supported
